Smithco Super Star Diesel 43-500 (sn 14560 – 14579) Parts & Service Manual - Manual (Page 134)

C-27
Rear Attachment
13-298Q FAN RAKE ATTACHMENT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 43-153 Frame 1
2 HB-14-20-200 Bolt 1 /
4
- 20 x 2 5
3 13-310 Rake 5
4 HNCL-14-20 Center Lock Nut 1 /
4
- 20 5
INSTALLATION INSTRUCTIONS
1. Assemble the five rakes (Ref 3) to the frame using the bolt and center lock nuts (Ref 2 and 4). Slide the
fan rake assembly under the rear of the trap rake to the hitch.
2. Attach the rake lift to the trap rake quick hitch, by sliding the the hitch into the spring loaded locking
mechanism.
3. With the rake on the ground pull the rake to the right side until it is 2-3 inches from the tire.
4. Repeat steps on left side.
5. Turn machine on and test for operation of rake assembly by raising and lowering the rake assembly. Also
with rake down, turn sharp corners to check that rake does not touch wheels.
13-319-K FAN RAKE KIT PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-326 Left Holder 1
2 13-329 Long Holder 2
3 13-327 Center Holder 1
4 13-328 Right Holder 1
5 29-541 Lock Pin 5
6 13-310 Rake 5
FAN RAKE KIT INSTRUCTIONS
1. Remove connector links that hold rake blades to rake frame if desired.
2. Remove groomer blades from rake frame that are held on with rake teeth studs (Ref A). Replace rake teeth
studs, if desired.
3. Place left holder (Ref 1), angle side up, to the second rake tooth hole from the end and install rake tooth stud.
The first rake tooth hole from each end (Ref B) have no rake teeth in them.
4. Remove the 8th rake tooth stud from the end of right and left rake frame and place long holders (Ref 2) on top,
reinstall rake teeth studs.
5. Remove rake tooth in direct center of rake and install the center holder (Ref 3). Reinstall rake teeth studs.
6. Place right holder (Ref 4), angle side up, to the second rake tooth hole from the end and install rake tooth stud.
The first rake tooth hole from each end (Ref B) have no rake teeth in them.
7. Slide fan rake (Ref 6) onto holders and pin with lock pin (Ref 5).