Smithco Super Star Diesel 43-500 (sn 14560 – 14579) Parts & Service Manual - Manual (Page 158)

C-51
Rear Attachment
72" COCO MAT FINISHER PARTS LIST
REF# PART# DESCRIPTION QUANTITY
1 13-688 Brush Channel 1
HB-14-20-075 Hex Bolt, 1 /
4
- 20 x 3 /
4
2
HNFL-14-20 Flange Lock Nut, 1 /
4
- 20 2
2 43-168 Brush Mount Arm 2
HB-14-20-075 Hex Bolt, 1 /
4
- 20 x 3 /
4
6
HNFL-14-20 Flange Lock Nut, 1 /
4
- 20 6
3 13-683 Brush Track 1
4 13-682 Brush, 77 x 11 1
5 43-164 Adjustment Handle 1
6 43-166 Mat Clamp 4
HB-38-16-125 Hex Bolt, 3 /
8
- 16 x 1 1 /
4
8
HNFL-38-16 Flange Lock Nut, 3 /
8
- 16 x 1 1 /
4
8
7 43-165 Frame 1
8 43-167 CoCo Mat, 27 x 72 1
9 43-162 Draw Bar 1
HHP-18 Bridge Pin, 1 /
8
1
10 43-163 Lock Handle 1
11 HCP-12-300 Clevis Pin, 1 /
2
x 3 1
HHP-18 Bridge Pin, 1 /
8
1
Some components of your CoCo Mat Finisher have been assembled at the factory for your convenience.
1. Start by mounting the Drawbar (Ref 9) to the Frame (Ref 7) using the Clevis Pin and Bridge Pin (Ref 11).
Position the Drawbar, using either set of holes, as illustrated.
2. Next, mount the Brush assembly (Ref 1, 3 & 4) to the Brush Mount Arms (Ref 2), as illustrated, using the
(6) 1 /
4
- 20 x 3 /
4
Hex Bolts and 1 /
4
- 20 Flange Lock Nuts. Secure fasteners tight.
3. The holes on each of the Brush Mount Arms will line up. Mount to the pin on the Drawbar (Ref 9) and
secure using the remaining Bridge Pin.
4. Thread the Lock Handle (Ref 10) on to the Adjustment Handle (Ref 5). Thread the Adjustment Handle into
the nut on top of the Drawbar (Ref 9), continuing until the threaded rod is through the Drawbar tube. Turn
the Lock Handle clockwise (
 ) to lock the Adjustment handle in place.
Adjusting the CoCo Mat Finisher.
Adjusting the leading edge (front) will affect the performance of the Finisher. Various field compositions
and conditions can benefit from fine tuning of the Finisher's leading edge angle.
1. Release the Lock Handle (Ref 10) by holding the Adjustment Handle (Ref 5) and turning the Lock Handle
counter-clockwise (

).
2. To raise the leading edge (front) of the Finisher, turn the Adjustment Handle clockwise (

). When you
obtain your desired position, turn the Lock Handle clockwise (  ) to lock the Adjustment handle in place.
3. To lower the leading edge (front) of the Finisher, turn the Adjustment Handle counter-clockwise (  ). When
you obtain your desired position, turn the Lock Handle clockwise (  ) to lock the Adjustment handle in
place.