Smithco Spray Star 1100e Operator Manual - Manual (Page 10)

8
Introduction
CONTROLS & INSTRUMENTS
A. Hour Meter - The hour meter indicates hours of machine operation. It operates only when the ignition
switch is on.
B. Speedometer - The Speedometer indicates ground speed of the vehicle in miles per hour and kilometers
per hour.
C. Ignition Switch - The ignition switch has two positions: Off - On.
D. Forward/Reverse - This rocker switch allows the machine to go forward by pushing on the top or reverse
by pushing on the bottom. NOTE: Machine MUST be in complete stop before moving the forward/reverse
switch.
E. Speed 1-2-3 - This rocker switch is used to control varying speeds in conjunction with the accelerator
pedal. Can be switched on the move.
Position 1: 0-3mph (0-5 kph)
Position 2: 0-5mph (0-8 kph)
Position 3: 0-9 mph (0-14 kph)
F. Lights - This rocker switch turns lights on by pushing on the top and off by pushing on the bottom.
G. Spray Pump - This rocker switch turns the spray pump on by pushing on the top and off by pushing on the
bottom.
H. Left Boom Switch - This rocker switch lifts and lowers the left
boom.
I. Right Boom Switch - This rocker switch lifts and lowers the
right boom.
J. Master Disconnect Switch - located on the right side of the
seat, this switch is used to shut down the electrical system
in case of emergencies. (This will shut down all electrical
systems.) When turned off it will deactivate the system. Use
this switch when maintenance work is needed to be done on
the machine.