Smithco Spray Star 1100e Operator Manual - Manual (Page 21)

19
Operation
INITIAL PROGRAMMING OF CONSOLE COMPUTER
When you first turn on Console power, after all installation procedures have been completed, the Console will
flash “CAL” in the RATE display and “US” in the DATA display. This means you must “calibrate” or program the
Console before it can be operated.
(This is a one time operation which does not have to be repeated unless you disconnect your battery wires.
Turning OFF the POWER ON/OFF switch does not affect the Console memory. All data is retained). The follow-
ing steps must now be followed.
If an entry selection error is made during steps 1, 2, 3, or 4, the Console can be reset by depressing for
20 seconds (Data displays US and RATE displays CAL.).
1. Displaying US, SI or TU
a. Depressing momentarily Steps the DATA display from US (acres) to SI(hectares) to TU (1000
sq ft) to US
2. Selecting US, SI or TU
a. To select US, SI, or TU, step until the desired code is displayed in DATA display.
b. Momentarily depress the DATA display will now display SP1.
3. Displaying SP1 or SP2 (select SP2)
a. Depressing momentarily steps the DATA display from SP1 (wheel drives, etc.) to SP2 (radar
sensor) to SP1.
4. Selecting SP1 OR SP2 (select SP2)
a. To select SP1 or SP2, step with until desired code is displayed in DATA display.
b. Momentarily depress the DATA display will now display 0.
5. Display C-SD (Standard Valve). C-F(Fast Valve), C-FC(fast Close valve), C-P(PWM Valve), C-PC(PWM
Close valve)
a. Depressing momentarily Steps the display from C-SD to C-F to C-FC to C-P to C-PC to C-SD.
6. Selecting C-SD (Standard Valve). C-F(Fast Valve), C-FC(fast Close valve), C-P(PWM Valve), C-PC(PWM
Close valve)
a. To select C-SD, C-F, C-FC, C-P, C-PC or C-SD step with until desired code is displayed.
b. Momentarily depress the display will now display CAL SELF TEST 0.0.