Smithy GN1300 - Manual (Page 33)

Handles
Install any handles or handwheels that have been removed for shipping. Handles can be
hand installed and tightened with a flat-head screwdriver. Remove and reverse the
tailstock handwheel.
Cleaning & Lubricating Your Machine
Smithy machines are shipped with a light protective grease coating that must be removed
prior to use. Use a noncorrosive kerosene or white mineral spirits to remove the coating.
WD-40® also works well.
Once cleaned, your Smithy must be lubricated. Make sure to lubricate carefully and
thoroughly before starting the machine. Use a pump oil can and a supply of good
quality SAE30 weight nondetergent oil or 30-weight compressor oil. Lubricants can be
obtained at most home and building supply stores. A lubrication point chart can be found
on the backside of the millhead.
Lubrication Schedule
Lubrication depends a lot on the use of your machine and your climate. The schedule
below is intended to be used as a guide, use your best judgement for lubricating your
machine based on your use and environment.
Check Oil Before each use
Oil Ports Before each use
Add Oil As Needed
See Chapter 11 for a complete maintenance schedule.
Lubrication Points
Follow the instructions on the next page and refer to the lubrication chart on the
backside of the millhead.
Figure 5.4 Installing Handles
Granite 1300 Series Operator’s Manual
5-3 For Assistance: Call Toll Free 1-800-476-4849