SoundFreaq SFQ-02RB - Manual (Page 14)

.13.
 The pair indicator starts blinking quickly to
indicate that the unit and your device have
put into the connection mode.
 When a Bluetooth connection is established
successfully, the indicator will be solid on.
5. Select Bluetooth mode by repeatedly pressing
the SOURCE button on the remote control
or pressing the Bluetooth button on the unit.
6. Select the desired music and press "Play"
button on your device. The unit automatically
starts playing the audio.
 Try again above steps 2 to 5 if the pair
indicator turns solid after blinking for 3
minutes, the pair was unsuccessful.
Using Multiple Bluetooth Devices
Only one device can be used at a time, but you
can switch between different Bluetooth devices.
Make sure each device you want to use has
already been paired, to switch devices:
1. On the Sound Step, press the pair button.
2.
On the Bluetooth device, select connect to the
Sound Step.
This device is now the connected device to the
Sound Step, (the previous connected device is
now disconnected). Repeat those steps to
switch the connected device again.
Note: If the unit has no sound output, please
check if the volume level of your Bluetooth
device connected to the system is set to the
minimum, or the Bluetooth device is muted.
Playing back from Macbook or Macbook
Pro
1. In the desktop screen, Select the “Open
Bluetooth Preference”.
2. If there is any old “Sound Step” records,
remove it. And then select “Setup New
Device” again.
3. Select “Sound Pla” and the type should be
“Audio” in the latest SFQ-02RB unit.
Click the “Continue” to proceed pairing
process.
4. Once completed, the pairing success screen
will come out.
Note: Don’t quit the page immediately. You
may notice that the previous dialog screen
still shows the device not connected. Just
ignore it. It’s confusing to the user. In fact,
it’s connected already.
5. Open iTune, play a song. Then use mouse to
click the Bluetooth icon and the top right
hand corner of the desktop screen, select
the “Sound Step” option and then select the
“Use as Audio Device (Stereo)”. After a while (a
few seconds), the music will come out
from the SFQ-02RB. If not, retry to select the
“Use as Audio Device (Stereo)” once again.
The Sound Quality should be good.
Playing back from PC/Notebook
1. Press the “Start” button to open the “Device
and Printers” dialog box.
2. Turn on the SFQ-02RB system and press the
PAIR button on the unit to put the unit into
the pair mode.
3. Select the “Add a device” in the “Device and
Printer” dialog box. The “Sound Step” icon
will appear on the display.
4. Double click the “Sound Step” icon and wait
until the device has been added successfully.
5. Click the “Close” button to close the “Device
and Printer” dialog box. A ”Sound Step” icon
appears in the dialog box.
6. Double click the “Sound Step” icon and the
device connection screen will be shown.
7. Click the “Connect” button in the “Music and
Audio” option.
8. Once connected, the pair indicator on the
unit will be solid on and the connection
success screen will be shown.