Sundance SMT387 - Manual (Page 25)

Version 1.0.3 Page 25 of 42 SMT387 User Manual
D4 Red DSP GP0
D5 Red DSP GP1
D6 Red FPGA LED0
D7 Red FPGA LED1 / PCI SATA
IDSEL*
*FPGA LED1 is used for PCI SATA IDSEL on SMT387V1 PCBs.
Table 5: LED Identification
See Figure 10: SMT387 Components placement-Top view.
Power Supplies
The PCI specifications state that the maximum power allowed for any PCI board is 25
Watts, and represents the total power drawn from all power rails provided at the
connector (+5V, +3.3v, +VI/O,+12V,-12V, +3.3Vaux). The expansion board (in our
case the TIM carrier board and the TIM modules) may optionally draw all this power
from either the +5V or +3.3V rail.
Nevertheless, it is anticipated that many systems will not provide a full 25 Watts per
connector for each power rail, because most boards will typically draw much less
than this amount.
For this reason it is recommended that you analyse the total FPGA device power
drawn by using
Xilinx XPOWER before implementing your design in the FPGA.
This will tell you if you need to use the external power connector provided on our
carrier boards. (Like the SMT310Q carrier board)
TI 6415 DSP FPGA
XC2VP SiI3512 ZBT RSL
Vccint/Vdd 1.2v 1.5v 1.8v 3.3v N/A
Vcco/Vddq 3.3v 3.3v 3.3v 3.3v N/A
Vpci N/A 3.0v N/A N/A N/A
Vccaux N/A 2.5v N/A N/A 2.5v
Table 6: Powering the devices.
DC/DC
converter
PC 3.3v
Voltage
regulator