Sundance SMT365 - Manual (Page 14)

Version 2.3 Page 14 of 28 SMT365 User Manual
Comports
The DSP has six comports, numbered 0 to 5.
The addresses of the ComPort registers are described in the SMT6400 help file .
SHB
The SMT365 has two SHB connectors, both of which are connected to the DSP to
give 32-bit SDB interfaces. These interfaces operate with a fixed clock rate of
100MHz.
Architecture
SDB0 and SDB2 on the DSP are presented on the TIM's SHB connectors, SHBA and
SHBB respectively.
SDB 2 SDB 0
The addresses of the SDB registers are shown in the Virtex Memory Map , and are
described in the SMT6400 help file .
Global bus
The SMT365 provides a single global bus interface. This is only accessible from the
DSP. The addresses of the global bus registers are shown in the
Virtex Memory Map ,
and are described in the SMT6400 help file .
LED Setting
The SMT365 has 9 LEDs. One shows the FPGA configuration status and the other 8
are under DSP control.