SVS PLASMA TWO User Manual
Page 4
PLEASE READ THROUGH ALL INSTRUCTIONS (INCLUDING ACCESSORY
INSTRUCTIONS) BEFORE PROCEEDING.
This lift is designed to be used with a remote control unit, either automatically or manually
controlled. The lift is supplied with a low voltage key switch controller (designed to be wall
mounted), which can be left in the "On" or "Off" position for normal operation.
Normal
safety requirements of handling heavy equipment must be followed.
1. PRELIMINARY INSTALLATION CHECKS:
•
The support structure should hold at least four (4) times the weight of the lift and plasma screen
combined. Always follow the local building codes.
•
Required space, lift support, and necessary cabling (i.e. low voltage control lines, audio/video control
and power supplies) should be considered or installed prior to the lift installation.
•
Do not install the plasma screen on the lift until the lift, hardware and any other accessories have been
properly installed and operational.
•
This lift has been adjusted at factory with cables tightly packed on the drum and leveled for precise
tracking, prior to being shipped from SVS Factory. Do not remove the lift's shipping block until
instructed to do so (see Section 4-5). SVS lifts are shipped in a slightly open position to eliminate stress
on the limit switches and to maintain a tight cable pack on the drum. If physical height measurements
are taken before the blocks are removed from the lift, they may not accurately reflect the actual
measurement of the lift in a closed position.
•
All weight attached to the lift must be centered between the lift's cables.
•
For ease of installation, lift can be hoisted into ceiling location with blocks and tackle or by using a
ratchet puller.
•
As a reminder, clear all persons and obstructions from the lift's path during its operation. Keep fingers
and other objects away from all moving parts. Technical Personnel should always be present whenever
the lift is being serviced.
SVS PLASMA TWO LIFT INSTALLATION
Page 4 of 13