SVS PLASMA TWO - Manual (Page 9)

5. CEILING CLOSURE INSTALLATION – Please refer to installation instructions included with
the #1 Ceiling Closure. It is the self-aligning closure system installed underneath the plasma screen and
used to conceal the ceiling hole when the lift and projector are raised in the ceiling. It is attached to the
unistrut channel on the lifts bottom mast stage.
6. ELECTRICAL WIRING AND LIFT CONTROL:
Electrical Connections should be made at this time. The Plasma Two lift is controlled with a low voltage
24v/AC controller (Key Switch Control Wall Plate).
This controller can be easily connected to external
controllers like Crestron, AMX etc.
S V S W A L L P L A T E
Figure 7.
How to use the low voltage controller:
a. To lower the lift, turn the keyswitch to the "ON" position and press the toggle down. When the lift
reaches its down limits, the lift will stop.
SVS PLASMA TWO LIFT INSTALLATION Page 9 of 13
VIEW FROM BACK
(24vac)
93
+
-
(ON)
C
2
1
GRN GRN
51
RED
UP
BLK
WHT
ORN
BLK
WHT
MOTOR
POWER ON
WHT
80
DOWN
ON-OFF-ON
RP2
(ON)
77
BLK
ORN
GRN GRN
RED
WHT
3 2 1
4 5 6
9
8
7
12
11
10