SVSi N-Series Windowing Processor - Manual (Page 4)

Installation Instructions
The windowing processor requires only two connections to install.
Attach the windowing processor to the network by connecting an Ethernet
cable to one of the three ports.
If the windowing processor will be used in a daisy-chain connect additional
Ethernet cable between the windowing processor and the other devices.
Connect the power cable to power on the windowing processor.
When not in use remove the power cable and disconnect any Ethernet cables
connected to the windowing processor.
Mounting Instructions
For rack mounting the windowing processor follow the steps below:
1. Attach the included rack mounting brackets to the windowing processor
using four of the included screws.
2. Insert the windowing processor into the rack and align the mounting
holes of the mounting brackets with the holes in the rack. Attached
using the remaining four screws.
3. Connect the appropriate cables as described above in Installation
Instructions.