Verilink XEL XSP-100 SHARK IAP (9SA-USRS-9.0R1.02) Product Manual - Manual (Page 149)

Chapter 6: Using the Command Line Interface (CLI)
SHARK™ IAD User’s Guide XEL P/N & Release 9SA-USRS-9.0R1.02 Chapter 6-33
The following E&M settings apply to only and all channels configured to an E&M signaling mode.
See page 6-52.
E
&
M
-
LOOP
-
GROUND
-
SELECT
e&m-loop-ground-select <mode>
where mode [loop | ground]:
The e&m-loop-ground-select selection controls the type of E&M signaling
conversion selection. The selections include loop-start (loop) and ground-start
(ground). The default is loop-start.
E
&
M
-
RINGBACK
e&m-ringback <mode>
where mode [enable | disable]:
The e&m-ringback selection enables or disables the SHARK™ IAD initiated
ringback tone to the call-originator (office end). The default is ringback tone is
enabled.
E
&
M
-
FORWARD
-
DISCONNECT
e&m-forward-disconnect <mode>
where mode [rev-batt | tip-open ]:
The e&m-forward-disconnect selection controls the method of forward
disconnect. The selections include reverse battery (rev-batt) and opening the tip
lead (tip-open). The default is reverse battery.
.
CONFIGURING
THE ROUTER
MODULE To begin entering router configuration commands, from the system prompt
enter:
SHARK010101000011> CONFIG
The SHARK™ IAD will enter the top node of the configurator.
Then enter:
(top)>> ROUTER
(ROUTER)>>
Enter the following commands from this node.
NOTE: See the save command on page 6-28 of this chapter about special
considerations when saving and loading ROUTER parameters.
S
YSTEM
S
ETTINGS
You can configure system settings to assign a name to your SHARK™ IAD and
to specify what types of messages you want the diagnostic log to record. Enter
the system level as shown:
SHARK010101000011> CONFIG
(top)>> ROUTER
(ROUTER)>>
system
name set name <name>
Specifies the name of your SHARK™ IAD. Each SHARK™ IAD is assigned a
name as part of its factory initialization. The default name for a SHARK™ IAD