Westermo TD-22 - Manual (Page 28)

29 6177-2203
&V – Display Current Configuration and Stored Profiles
Reports the current (active) configuration, the stored (user) profiles, and the first four stored
telephone numbers. The stored profiles and telephone numbers are not displayed if the NVRAM is
not installed or is not operational as detected by the NVRAM test during reset processing.
AT&V
ACTIVE PROFILE:
B0 E1 L1 M1 N1 Q0 T V1 W0 X4 Y0 &C0 &D0 &G0 &J0 &K3 &Q5 &R1 &S0 &T5 &X0 &Y0
S00:002 S01:000 S02:043 S03:013 S04:010 S05:008 S06:010 S07:050 S08:002 S09:006
S10:014 S11:095 S12:050 S18:000 S25:005 S26:001 S36:007 S37:000 S38:020 S44:020
S46:138 S48:007 S95:000
STORED PROFILE 0:
B0 E1 L1 M1 N1 Q0 T V1 W0 X4 Y0 &C0 &D0 &G0 &J0 &K3 &Q5 &R1 &S0 &T5 &X0
S00:002 S02:043 S06:010 S07:050 S08:002 S09:006 S10:014 S11:095 S12:050 S18:000
S36:007 S37:000 S40:168 S41:195 S46:138 S95:000
STORED PROFILE 1:
B0 E1 L1 M1 N1 Q0 T V1 W0 X4 Y0 &C0 &D0 &G0 &J0 &K3 &Q5 &R1 &S0 &T5 &X0
S00:002 S02:043 S06:010 S07:050 S08:002 S09:006 S10:014 S11:095 S12:050 S18:000
S36:007 S37:000 S40:168 S41:195 S46:138 S95:000
TELEPHONE NUMBERS:
0= 1=
2= 3=
OK
Please also refer to AT\S
Wn – Connect Message Control
This command controls the format of CONNECT messages. The parameter value, if valid, is written
to S31 bits 2 and 3. Note that the Wn command can be overridden by register S95 bits (see S95
description).
W0 Upon connection, the modem reports only the DTE speed. Subsequent responses are
disabled. (Default.)
W1 Upon connection, the modem reports the line speed, the error correction protocol, and
the DTE speed, respectively. Subsequent responses are disabled.
W2 Upon connection, the modem reports the DCE speed. Subsequent responses are
disabled.
Please also refer to AT&Q
&Wn – Store Current Configuration
Saves the current (active) configuration (profile), including S-Registers, in one of the two user
profiles in NVRAM as denoted by the parameter value.
The current configuration is comprised of a list of storable parameters illustrated in the &V
command. These settings are restored to the active configuration upon receiving an Zn command or
at power up (see &Yn command).
&W0 Store the current configuration as profile 0.
&W1 Store the current configuration as profile 1.
Please also refer to AT&Y