Westermo TD-22 - Manual (Page 38)

39 6177-2203
S29 – Flash Dial Modifier Time (Not stored with the AT&W command. Only for Germany)
Sets the length of time that the modem will go on-hook when it encounters the flash (!) dial modifier
in the dial string.
Default 0 (disabled) {0-255} 10 ms intervals.
S30 – Disconnect Inactivity Timer
Sets the length of time that the modem will stay on-line before disconnecting when no data is sent or
received.
Default 0 (disabled) {0-255} ten seconds (0-2550 seconds)
S31 – Bit Mapped Options Status (Read only)
Bit 0 Reserved
Bit 1 Controls auto line speed detection (Nn)
0 =
Disabled (N0)
1 = Enabled (N1) (Default.)
Bits 2-3 Controls error correction progress messages (Wn)
0 =
DTE speed only (W0) (Default.)
1 = Full reporting (W1)
2 = DCE speed only (W2)
Bit 3 Reserved
Bits 4-7 Reserved
S32 – XON Character
Sets the value of the XON character.
Default 17 {0-255} ASCII decimal.
S33 – XOFF Character
Sets the value of the XOFF character.
Default 19 {0-255} ASCII decimal.
S36 – LAPM Failure Control
This value indicates what should happen upon a LAPM connect failure.
0 = Modem disconnects.
1 = Modem stays on-line and a Direct mode connection is established. (AT\N1)
2 = Reserved.
3 = Modem stays on-line and a Normal mode connection is established. (AT\N0)
4 = An MNP connection is attempted and if it fails, the modem disconnects. (AT\N5)
5 = An MNP connection is attempted and if it fails, a Direct mode connection is established.
6 = Reserved.
7 = An MNP connection is attempted and if it fails, a Normal mode connection is established. (AT\N3)
Default 7 {0..7}
Please also refer to S48, AT\N
S37 – Desired Line Connection Speed
Bits 0-3
Desired line connection speed. This is interlinked with the Fn command. If an invalid
number is entered, the number is accepted into the register, but S37 will act as if the
default value has been entered.
0 = Attempt auto mode connection (F0). (Default)
1-3 = Attempt to connect at 300 bps (F1).
4 =
Reserved.
5 = Attempt to connect at V.22 1200 bps (F4).
6 = Attempt to connect at V.22 bis 2400 bps (F5).
7 = Attempt to connect at V.23 (F3).