Westermo TD-22 - Manual (Page 37)

38 6177-2203
Bits 6-7 Guard tone (&Gn)
0 =
None (&G0)
1 = None (&G1)
2 = 1800 Hz (&G2) (Default.)
S24 – Receiver disconnect level
If %D1 is set, will the value in this register set the level of the lowest accepted linesignal
Default 0 {0-43} (dBm)
S25 – Delay To DTR
Sets the length of time that the modem will ignore DTR for taking the action specified by &Dn.
Default 5 {0-255} hundredths of a second)
S26 – RTS to CTS delay
Sets the length of time between RTS and CTS.
Only working in synchronous connections
Default 1 {0-255} hundredths of a second)
S27 – Bit Mapped Options Status
Indicates the status of command options.
Bits 0 -1,3 — Asynchronous selection (&Qn)
3
1 0
0 0 0 = &Q0
1 0 0 = &Q4
1 0 1 = &Q5 (Default.)
1 1 0 = &Q6
Bit 2 Reserved
Bits 4-5 Internal clock select (&Xn)
0 =
Internal clock (&X0) (Default.)
1 = External clock (&X1)
2 = Slave clock (&X2)
Bit 6 CCITT/Bell mode select (Bn)
0 =
CCITT mode (B0) (Default.)
1 = Bell mode (B1)
Bit 7 DTR dial option (AT&B)
0 =
No DTR dial (&B0) (Default.)
1 = Dial on DTR low to high transition (&B1)
S28 – Bit Mapped Options Status (Read only register)
Bits 0-1 Reserved
Bit 2 Reserved (always 0).
Bits 3-4 Pulse dialling (&Pn)
0 =
39%-61% make/break ratio at 10 pulses per second (&P0) (Default.)
1 = 33%-67% make/break ratio at 10 pulses per second (&P1)
2 = 39%-61% make/break ratio at 20 pulses per second (&P2)
3 = 33%-67% make/break ratio at 20 pulses per second (&P3)
Bit 5 Reserved
Bits 6-7 MNP Link Negotiation Speed (*Hn)
0 =
Link negotiation at highest speed (*H0) (Default.)
1 = Link negotiation at 1200 bps (*H1)