ZeeVee HDbridge Advanced - Manual (Page 11)

HDbridge™ Module Configuration Manual Page 11
www.zeevee.com Rev 1.0
MPEG Encoding
The Output Data Rate defaults to 34.
However, some HDTVs may show break-up
with fast motion video (mostly Sharps, but
also some older LGs or Samsungs).
If so, select a lower data rate.
Hit “Apply” to save your changes.
For advanced MPEG Encoding options:
1. Click the “Advanced Configuration” link.
2. Audio and Video Delay: Set audio and
video delay independently to adjust for
lip sync issues.
3. DC Coefficient: Used in the encoding
process, this can affect picture quality
and some HDTVs’ ability to display.
4. PID and Program Number: Often needed
when using a custom cable set-top box
instead of the HDTV tuner.
5. Hit “Apply” to save your changes.
IMPORTANT NOTE: Advanced Option changes for MPEG encoding are rarely needed.
It is strongly recommended that you avoid making changes unless all other options fail.
IP Configuration
1. IP Address Type: DHCP is set by default. IP
addresses will be assigned by the local
DHCP server.
2. Static IP Address Configuration: Static IP
addresses can be assigned. Select “Static”
in “IP Address Type” (above) and enter the
appropriate IP address, Mask, and Default
Gateway.

Important Note: Resetting to defaults
via WebManager or the reset pin on
back of the unit will also change the IP
settings back to “DHCP.” This is
important because if a static IP address
is set and you lose access because of
the settings, you can reset it by using
the pin on the back of the unit.
3. Hit “Apply” to save your changes.







