AEC 3-Pump 33-Station Controllers - Manual (Page 26)

3–Pump 33-Station Controllers Chapter 3: Installation 25 of 51
4. As appropriate, either continue copying to other pumps, or touch Return to go back
to the “Pump Setup” screen.
• Copying to a Range of Other Pumps:
1. On the “Pump Copy” screen (Figure 10) touch the gray First Pump button. The
keypad pops up.
2. Enter the pump number for the lower end of the range you are copying to. Use
(Backspace Key) to erase any mistakes. Use (Enter Key) to enter the value.
The keypad disappears, and the “Pump Copy” screen shows the pump number you
entered under First Pump.
3. On the “Pump Copy” screen (Figure 10), touch the gray Last Pump button. The
keypad pops up.
4. Enter the pump number for the upper end of the range you are copying to. Use
(Backspace Key) to erase any mistakes. Use (Enter Key) to enter the value.
The keypad disappears, and the “Pump Copy” screen shows the pump number you
entered under Pump Station.
5. Touch the green Copy to Range of Pumps button. Complete briefly appears on
the screen.
6. As appropriate, either continue copying to other pumps, or touch Return to go back
to the “Pump Setup” screen.
• Copying to All Other Pumps:
1. On the “Pump Copy” screen (Figure 10), touch the green Copy to All Pumps
button. Complete briefly appears on the screen.
2. Touch Return to go back to the “Pump Setup” screen.
Finishing Setup: Setting Up Passwords
You can set up passwords for two levels of security: for operators and for setup personnel.
The controller comes from the factory with neither password set. This allows every user
access to all functions.
Setup Password
If you define a password for setup personnel, then most settings can be changed only after
entering the password. The password will be required to display the following screens:
• System Setup (to review and change system-wide settings, clear the alarm log, and go
to the network status screens).
• Station Setup (to review and change settings for all station options).
• Pump Setup (to review and change settings for all pump options).