AEC 3-Pump 33-Station Controllers - Manual (Page 40)

3–Pump 33-Station Controllers Chapter 4: Operation 39 of 51
Standby Pump Errors
If the error message tells you to disable the source pump and/or the standby pump, touch
Return at this screen, then Pumps at the “Pump Setup” screen. Take the pumps offline and
then return to the “Transfer to Standby Pump” screen.
If the error message tells you that the standby pump has stations assigned, you must either use
a different standby pump or you must remove the pump assignment for all stations assigned
to the standby pump. To remove the assignments, complete the following steps:
1. Touch Return at the “Standby Pump” screen, and then touch Menu.
2. From the “Menu” screen, touch Stations.
3. Touch and hold a station icon to get to the “Station Operator” screen.
4. Then touch Setup to go to the “Station Setup” screen.
5. Use _ Back. and Next _ to review all pump assignments.
6. Where necessary, choose Assigned to Pump #n to set station assignments to 0
(unassigned). Then return to the “Transfer to Standby Pump” screen.
4-3 Alarms
Reviewing Alarms
To review your system’s alarms, touch Alarms on “Menu” screen. The “Alarm Log” screen
appears, with the newest alarm listed first.
Figure 18: Alarm Log Screen
To scroll up and down through the list, touch _ and _ at the bottom of the list.