AEC OFC Series - Manual (Page 11)

OFC Series Extrusion Control Units Page 11
Safety 2
2-1 Work Rules
Install, operate, and maintain this equipment according to
applicable work and safety codes for your location. This includes
OSHA, CE, NEC, CSA, SPI, and many other local, national, and
international regulations. Obey these specific work rules:
Read and follow the instructions in this manual before
installing, operating, or maintaining any equipment.
Additional copies are available from AEC, Inc.
Only qualified persons should work on, or with, this
equipment.
Work only with approved tools and devices.
Disconnect and lock out power while working on this
equipment.
2-2 Tools and Equipment Needed
You’ll need the following:
• Hand tools
• Fork lift or overhead lift
• Wire, conduit, and fittings for wiring runs (if receptacle is not
already in place)
• Mounting bolts with nuts and washers
2-3 Mechanical Installation
Blenders may be mounted on the machine, a stand, or a mezzanine.
Be sure it is securely attached and additional bracing is used if
necessary. The sections on the following pages explain general
installation rules.
Read manual thoroughly before installing
blender.
Use approved safety straps or chains to lift the
blender at the marked lifting points.