Elation Professional DESIGN WASH 250 - Manual (Page 15)

14 DESIGN WASH 250 USER MANUAL V1.0 NR
4. Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
- Switch 16 bit/8 bit
With this function you can switch the device from 16 bit to 8 bit resolution.
1. Select “16BI” by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or press [DOWN] button to “OFF” if you don’t.
5. Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
- Pan degree select
With this function you can select pan angle 630 0 or 540 0.
1. Select “DEGR” by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows “630” or “540”.
3. Press [UP] to select “630” or press [DOWN] button to select“540”.
4. Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
Mic Sensitivity
With this function you can adjust the mic sensitivity
1. Select “MIC” by pressing [UP] or [DOWN] button
2. Press [ENTER], the display shows “M-xx”, XX stands for 0-90(the default setting is 70).
3. Press [UP] or [DOWN] to set the desired value for Mic Sensitivity
4. Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
- Automatic Run by no DMX
With this function you can run the automatic program of the device by no DMX.
1. Select “AUTO” by pressing [UP] or [DOWN] button.
2. Press [ENTER], the display shows “ON” or “OFF”.
3. Press [UP] to select “ON” if you wish to enable this function or press [DOWN] button to “OFF” if you don’t.
4. Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
Sound Run by no DMX
With this function you can run the sound controller of the device. by no DMX
1. Select “SOUN” by pressing [UP] or [DOWN] button.
2. Press [ENTER], The display will show “ON” or “OFF”
3. Press [UP] to select “ON” if you wish to enable this function or press [DOWN] button to “OFF” if you don’t.
4. Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu.
Fans mode select
With this function you can select the fan’s speed of the device
1. Select “FANS” by pressing [UP] or [DOWN] button
2. Press [ENTER], The display will show “HIGH” or “AUTO”(the default setting is AUTO)
3. Press [UP] to select “HIGH” if you wish to enable this function or press [DOWN] button to “AUTO” if you
don’t.
3. Press [ENTER] to confirm or Press [MODE/ESC] to return to the main menu
- Reset
With this function you can Reset the device via the Control Board.
1. Select “REST” by pressing [UP] or [DOWN] button.
2. Press [ENTER] to reset or Press [MODE/ESC] to return to the main menu.