Elation Professional DESIGN WASH 250 - Manual (Page 3)

2 DESIGN WASH 250 USER MANUAL V1.0 NR
• dimmer intensity: 0%~100%
• auto programs 8 pre-built programs can be selected
• lamp on/off control lamp on/off by DMX512 controller
• display : can turn 180° if the mounting location so requires
• local or remote resetting
• lamp switches ON/OFF locally
• auto test for all functions
• value of each DMX-channel can be displayed
• save program:
edit and save the program to the incorporated EEPROM through the front control panel or external
controller can save maximum 48 scenes, and run the saved program by the “run” menu from the
control panel
SAFETY INSTRUCTIONS
CA UTION
Be very careful during installation. Since you will be working with a dangerous
voltage you can suffer a l ife-threatening electric shock when touching live wires.
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
IM PORTA NT
Damages caused by the disregard of this user manual are not subject to warranty.
The dealer will not accept liability for any resulting defects or problems.
If the device has been exposed to temperature changes due to environmental changes, do not switch it
on immediately. The arising condensation could damage the device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device should be earthed.
The electric connection must carry out by qualified person.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by
the manufacturer or his service agent or a similar qualified person in order to avoid a hazard
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,
replacement of the cable must be done by an authorized dealer.