Eaton Electrical Powerware BladeUPS Bar - Manual (Page 19)

INSTALLATION
EATON Powerware ® BladeUPS ® Bar Installation Guide S 164201723 Rev P01 15
21. Using four M5 ×16 hex bolts and four M5 cage nuts, secure the
front cover mounting panel to the front of the rack. Verify that the
bent edge of the panel is at the top. See Figure 11.
Install the lower bolts and cage nuts into the second holes from the
bottom of the rack frame. Torque the bolts to 5.1 ± 0.8 Nm
(45 ± 7 lb in).
M5 × 16 Hex Bolts
and M5 Cage Nuts
(4 places)
Front Cover
Mounting Panel
Front of Rack
Bent Edge of Panel
Figure 11. Front Cover Mounting Panel Installation