Airlink AR315W - Manual (Page 39)

PC Configuration
35
Wireless Station Configuration
This section applies to all Wireless stations wishing to use the Wireless Router's Access Point,
regardless of the operating system that is used on the client.
To use the Wireless Access Point in the Wireless Router, each Wireless Station must have
compatible settings, as follows:
Mode The mode must be set to Infrastructure.
SSID (ESSID) This must match the value used on the Wireless Router. The default
value is
default
Note! The SSID is case sensitive.
WEP and WPA By default, WEP and WPA on the Wireless Router is disabled.
• If WEP and WPA remain disabled on the Wireless Router, all
stations must have WEP and WPA disabled.
• If WEP or WPA is enabled on the Wireless Router, each station
must use the same settings as the Wireless Router.
Note:
By default, the Wireless Router will allow both 802.11b and 802.11g connections.