Alinco EJ-50U - Manual (Page 30)

30
CMDTIME, press the C key 3 times with the Ctrl key pressed. <CTRL+C>
6-3-2 TRFLOW command
Abbrev. TRF default OFF range ON/OFF
example TRF OFF
When ON, activates the software-flow function for the modem to host communication in the transparent mode.
ON: Software-flow is activated. In this mode, the control codes for the soft-flow won’t be forwarded correctly, so
it becomes “imperfect transparent mode”. The TNC responds to software flow control from the terminal.
OFF: Soft-flow is not activated.
6-3-3 TXFLOW command
Abbrev. TXF default OFF range ON/OFF
example TXF OFF
Activates soft-flow function for the host to modem communication in the transparent mode.
ON / OFF parameters are the same as 6-3-2.
6-4 Automatic mode change
The automatic mode select functions can be activated.
6-4-1 NOMODE command
Abbrev. NO default OFF range ON/OFF / NO OFF
Selects activation of automatic mode change function.
ON: Automatic mode change is not activated.
OFF: Activate automatic mode change. Set parameters using CONMODE and NEWMODE commands.
6-4-2 CONMODE command
Abbrev. CONM default CONVERS range CONVERS/TRANS
example CONM C
Selects either converse or transparent mode (as designated) when a connection occurs.
C or CONVERS: To enter to converse mode.
T or TRANS: To enter to transparent mode.
6-4-3 NEWMODE command
Abbrev. NE default OFF range ON/OFF
example NE OFF
Sets the timing to automatically enter to the selected mode.
ON: Enters the selected mode immediately after the connect command is sent.
OFF: Enters the selected mode only when the confirming packet is received from the destination and the
connection is completed. The TNC does not automatically return to the command mode when
disconnected.
6-5 KISS mode
This is a special mode to enable protocol control from the PC. Specific KISS mode software is necessary. The
EJ-50U is compatible with KISS but in a very limited manner. We do not recommend the use of this mode.
KISS Mode bypasses most functions of the TNC and relies on the software in use to transfer data. Because