Alinco EJ-50U - Manual (Page 36)

36
No unrelayed station in the relay route
Relay modification process
Sender’s SSID is replaced with 0
MYCALL setting callsign is inserted at the end of the relayed station list.
Adds relay station list according to the parameter:
SSID=8: Relay station list set at NPATH command, 9:SPATH, 10:EPATH, 11:WPATH
(more than 8 stations including relayed wont be added)
Example: UISSID ON MYCALL W1AAA, NPATH S1,S2,S3
W1BBB>GPS-8:Frame1->W1BBB>GPS,W1AAA*S1,S2,S3,:Frame1
W1BBB>GPS-8,D1,D2,D3,D4,D5*:Frame2
W1BBB>GPS, D1,D2,D3,D4,D5 ,W1AAA*,S1,S2:Frame2
(More than 8 stations are not added)
W1BBB>GPS:Frame4->SSID is 0 thus UISSID command does not relay.
W1BBB>GPS-8,WIDE:Frame5-> There are unrelayed stations, so UISSID does not relay.
When SSID is set 12-15, the frames that match all below conditions will be relayed. When it is relayed, the
frame will be processed as below.
Relay condition: Frames that satisfy
The first UI frame heard within the UICHECK command set time.
UISSID command is on
Sender’s SSID is 12-15
No unrelayed station in the relay route
Relay modification process
Sender’s SSID remain unchanged.
Only the first relay station digipeated will remain, rest of relayed stations will be deleted.
MYCALL setting callsign will be inserted with relayed flag.
Adds relay station list according to the parameter:
SSID=12: Relay station list set at NPATH command, 13:SPATH, 14:EPATH, 15:WPATH
(more than 8 stations including relayed wont be added)
Example: UISSID ON MYCALL W1AAA, NPATH S1,S2,S3
W1BBB>GPS-12:Frame1->W1BBB>GPS-12,W1AAA*S1,S2,S3,:Frame1
W1BBB>GPS-12,D1,D2,D3,D4,D5*:Frame2->
W1BBB>GPS-12,D1,W1AAA*,S1,S2,S3:Frame2 (after the 2
nd relayed station list deleted)
W1BBB>GPS:Frame4->SSID is 0 thus UISSID command does not relay.
W1BBB>GPS-12,WIDE:Frame5-> There are unrelayed stations, so UISSID does not relay.
8-3-7 NPATH command
Abbrev. NPATH default empty range 7 callsigns
example NPATH W1YYY,W1ZZZ
NPATH % (empty)
In the UISSID command, sender’s callsign SSID is 8 or 12, it sets the relay route to be added to the relay station
list. If SSID is in excess of 8, station won’t be added. Even if NPATH is empty, the relay with UISSID takes place,
but without adding the relay route. Enter % to intentionally clear the value.