Alinco EJ-50U - Manual (Page 31)

31
virtually any combination of characters can be passed by the software in use, protocols dictate that it must be very
difficult to exit the KISS mode, once it has been activated. If you find the TNC in KISS mode and you wish to exit,
you may use the TCP/IP command found in most KISS software or you may try sending a special sequence from
your keyboard:
1. Press and hold the ALT key. Enter the numbers 192 from the numerical keypad NOT THE TOP OF THE
KEYBOARD. Then release the ALT key.
2. Again press and hold the ALT KEY and enter the numbers 255 from the numerical keypad. Release the ALT
key.
3. Finally, press and hold the ALT key. Enter the numbers 192 from the numerical keypad. Release the ALT
key.
Provided your terminal control program sent the characters properly, the TNC should exit the KISS mode and you
should see the cmd: prompt.
Chapter 7
Intentionally left blank.
8 Digipeat function
When the EJ-50U is installed into certain ALINCO transceivers, the radio and TNC can function as a digipeater.
The detail of UI frames are also explained in this chapter.
8-1 Digipeat related commands
8-1-1 DIGIPEAT command
Abbrev. DIG default ON range ON/OFF
example DIG ON
Selects the desired Digipeat mode.
ON: It functions as a digipeater. If the MYCALL or MYALIAS parameter is contained in the digipeat route data
received, the packet is relayed.
OFF: The digipeat mode is deactivated. Packets containing MYCALL or MYALIAS in their routing are ignored.
8-1-2 MYALIAS command
Abbrev. MYA default N/A range 6 characters alphanumeric + SSID
example MYA K6ANC-10
Used to set a callsign or alias exclusively used for digipeating. Do not set the same callsign used for MYCALL.
Change the SSID. If the parameter is set to other than a callsign, activate HID command ON to transmit which
station is relaying.
8-1-3 HID command
Abbrev. HID default: ON parameters: ON/OFF
example: HID ON
When ON, 9.5Minutes after having acted as a digipeater, the TNC sends an ID packet automatically. It does not
do so when OFF.
If MYALIAS is set other then a callsign, set this command ON to identify your station.
8-1-4 ID command
Abbrev. ID default:N/A parameters: N/A
example: ID