Aquatic AV AQ-IP-3B - Manual (Page 5)

Press on this button on the left as
indicated below to unlock the
iPod mechanism.
E - 4
INSTALLING iPod INTO THE BUILT-IN iPod DOCKING STATION
Always follow the below steps to install the iPod into the docking station.
Incorrect or improper installation may cause permanent damage to the
docking or the iPod unit. station
Push the docking back
into the cabinet
Press down this button
Pull out this stick
Plug connector into
Push inwards
Press towards the iPod unit to hold the
Step 1
Step 2
Step 3
Step 4
Press down the button as indicated
below to unlock the iPod docking.
Pull out the iPod mechanism.
as shown below.
Pull out the iPod connector
as indicated below.
(A).Once the stick is
Push the stick & the connected iPod
inwards until it stops.
Press the iPod on both mechanism.
sides to hold the iPod firmly in place.
Push the iPod inwards into
the unit’s cabinet until it stops.
dock
completely pulled out,
user should see the
iPod connector,
(B). user can
connect
the iPod
to the
connector
as shown in this step.
Step 5
Step 6
Step 7
Step 8
iPod unit firmly in place
3. iPod OPERATION
Press down
Never pull out this stick unless
docking is completely release out.
Pull out
(A)
(B)
bottom of iPod