ARM Electronics NDVR16 - Manual (Page 47)

47
10 : Calendar. You can select date and time to search pictures recorded at selected time and date. You
can refer to start and end of recording in 7.
Notice : We recommend you to click operation buttons one after the other with enough time interval to
give long enough time for DVR unit to execute commands from client PC. Too short time
interval between two clicks may cause system hang-up in client PC.
Notice : From time to time, connection shall be cut unexpectedly due to conditions of network line.
Whenever it is cut, quit search window by pressing power switch(1), and then press connect
button in live-view window and scan button to enter into search window again, to continue
searching.
Notice : Compatibility of Remote Viewer Software with different kinds of operating systems and PC
hardware may not be simply specified due to the characteristics of network that it is much
related with not only PC hardware and operating system but also other software installed on the
client PC and conditions of network(internet) line. Basically, DVR’ Remote Viewer Software is
compatible with typical Windows operating system from Windows 98 to Windows XP.
Notice : To see continuous live view, we recommend not to select motion recording in RECORD SETUP
menu of DVR. If it is set at motion recording in SETUP menu of DVR, image transmission is
done only there is motions detected.
Notice : While you search recorded data using client software in client PC, DVR unit to which you access
via IP network is in playback mode, and no recording is done as far as you search recorded data.
However, while you are in connection with DVR unit via IP network for live view, DVR unit
continues to record but at a little low recording rate.
Notice : At this DVR unit networking display, only one user can view the image through Internet.