Eneo HDC-2180Z03 D - Manual (Page 23)

Operating Instructions
23
FULL-HD AF ZOOM CAMERA
• CAM ID – Assigns the camera ID from 1~255 for the comm. address.
• BAUD RATE – Selects the baud rate from 2400~115200.
• PROTOCOL – Selects the comm. Protocol from PELCO-D/P or VISCA.
8-1. TV SYSTEM (default: US or EU)
: Selects HDTV standards for US
(60HZ) or EU(50HZ). By this
selection, 2nd analog video
output switches to NTSC or PAL
accordingly.
8-3. COMM. SET UP
: COMM. SETUP defines the CAM ID, BAUD RATE and PROTOCOL.
Data length, stop bit and parity are fixed to 8bit, 1stop bit and no parity bit.
8-4. LANGUAGE (default: ENG)
: 8 languages are available for ENGLISH, TURKISH, GERMAN, FRENCH,
ITALIAN, SPANISH, POLISH and JAPANESE.
When changing LANGUAGE, select the prefer language.
8-5. FACTORY DEFAULT (default: NO)
: RECALL ☟roads and saves the factory defaults.
8-2. RESOLUTION (default: 1080P)
: Three resolutions,1080P/720P(SCALED)/720P(CROPPED) are available.
1080P outputs 1920x1080 video at the frame rate of 30P/25P.
720P(SCALED) Image is scaled down from 1080P and outputs 1280x720
video without loss of field of view at the frame rate of 30P/25P.
720P(CROPPED) image is cropped at the center area from the image sensor
and outputs 1280x720 video at the frame rate at 60P/50P but the image refresh
rate is 30P/25P. Cropped image has narrowed field of view
SYSTEM
TV SYSTEM
RESOLUTION
COMM. SETUP
LANGUAGE
FACTORY DEFAULT
RETUTN EU(PAL)
1080P
ENG☟
NO
RET
8. SYSTEM
( Refer to ‘TIP’ for setting RS-485 communication with PTZ Controller)
• O-ZOOM RATIO: Set the Optical Zoom Ratio from OX 1.1~OX3.0 (~OX2.4)
• D-ZOOM RATIO: Set the Digital Zoom Ratio from DX 1.1~DX5.0
• STAYING ZOOMING : Sets the duration time for preset zoom area.