Eneo HDB-2080M2810IR D - Manual (Page 10)

Installation Instructions
FULL-HD MEGA-PIXEL CAMERA
10
Torque Wrench
Assembly Screw
: 4x14mm
Mounting Screw
: 4x30mm
1. Locate the mounting template at the installation position and drill the ceiling or
wall if needed. ( *The easy bracket can not be installed on the ceiling)
2. Place the easy bracket on pre-drilled position and fix it through using mounting
screws (4x30mm). Skip this step when an easy bracket is not installed.
3. Route the Power cable to the connecting place.
Hook up the camera bracket with the easy bracket as illustrated below.
4. Fix the camera bracket through using assembly screws (4x14mm).
5. Set the camera’s viewing angle and adjust zoom/focus of lens by using the torque
wrench.
6. Put the sunshield to the camera unit and tighten the sunshield-bolts.
REAR VIEW
1
2
3
4
Cable exit