Eneo HDB-2080M2810IR D - Manual (Page 18)

Operating Instructions
FULL-HD MEGA-PIXEL CAMERA
18
• POP ON FOCUS (OFF) :
ON zooms in the center of picture at 2X for better focusing.
• FOCUSING STATUS (ON) : Shows how exactly focus is set. When blue bar
doesn’t show up, try the lens focus to NEAR and FAR. The maximum blue bar
indicates the best focusing position.
4-1. NORMAL (default)
4-2. WDR
4-3. D-WDR
4. SCENE ENHANCE
: Optimized for the normal indoor and outdoor in the good lighting condition.
: Improves the visibility for the high bright area and the dark area by the double
captures of image with LONG and SHORT exposures. With WDR ON, the
frame rate becomes half by the double captures. WDR level can be selected
from LOW, MID and HIGH. Care should be taken to select this mode because
video may lose its quality in some environments by the over compensation.
※ CVBS video signal:Connecting 2nd video to CVBS port disables WDR function
temporary. It should be considered when installer adjusts the video with
installation monitor via CVBS video signal.
: Improves the visibility by compensating the video gain for the dark area.
Noise can increase in the dark area accordingly.
3D-NR is a very sophisticated and powerful time-based noise reduction technology
by monitoring the noise for the several video frames and defining and eliminating
them consecutively at low light. Higher setting reduces noise much more but results
in losing the sharpness and the tail effect or the motion blur for the fast moving
target at low light.
4-4. BLC
4-5. HLC
5. 3D-NR
: Cuts out the highlight area with black mask and excludes it from compensation.
Lower HLC LEVEL cut out video from the lower level.
: Improves the visibility for the dark object by the bright back light.
Outside area of BLC window can over saturate.
BLC has a target window for compensation and its size and position can be set
by H-POS, V-POS, H-SIZE and V-SIZE.