Eneo HDB-2080MIR - Manual (Page 13)

12
3D-NR MID
Enables to set OFF, LOW, MID and HIGH.
3D-NR is a very sophisticated and powerful time-based noise reduction
technology by monitoring the noise for the several video frames and defining
and eliminating them consecutively at low light.
Higher setting reduces noise much more but results in losing the sharpness
and the tail effect or the motion blur for the fast moving target at low light.
DAY/NIGHT EXT
Sets DAY / NIGHT to EXT, AUTO, COLOR and B/W.
SMART IR can be set to reduce the saturation by the strong IR illumination
in the night in any menu of EXT, AUTO and B/W(NIGHT)
Setting SMART IR in any menu is identically applied to other menu.
Zero(0) turns off SMART IR and High setting avoids the saturation strongly
but the corners will be darker accordingly.
Installation surrounding lots of IR LEDs ON is not recommendable.
The Light of IR LEDs may cause unwanted and frequent
Day & Night Filter switching and it affects the lifetime of IR Cut Filter.
In case of installation at lots of IR LEDs ON,
change the Day & Night mode to COLOR(DAY).
EXT – DAY or NIGHT is determined by the built-in light photo sensor.
Camera with IR LED must be set to EXT.
AUTO – Used when DAY or NIGHT is determined by light level through
the lens and DAY from/to NIGHT is switched automatically by the
scene brightness.
D<-->N THRESHOLD, D<->N GAP, D<->N DELAY, and SMART IR can
be set in the menu.
When EXPOSURE>AGC is less than 10, DAY/NIGHT AUTO is disabled and
forcibly switches to ___(DAY) to avoid the malfunction.
EXT, B/W(NIGHT) and COLOR(DAY) is independent on AGC level.
B/W(NIGHT) – Forcibly removes IR cut filter and switches to B/W
regardless of light level.
COLOR(DAY) – Forcibly DAY/NIGHT is disabled and outputs color video.
PICT ADJUST
Sets WHITE BAL, SHARPNESS, COLOR GAIN, GAMMA, SHADING.
See ‘6.7 PICT ADJUST’ for detail.
SPECIAL
Sets MIRROR/FLIP, PRIVACY, MOTION, MOTION ZOOM, PIXEL DEFECT,
TITLE SET, DISPLAY, DEFOG, POINTING ZOOM
TV SYSTEM. See ‘6.8 SPECIAL’ for detail.
SYSTEM
Sets TV SYSTEM, RESOLUTION, COMM.SETUP, LANGUAGE and
FACTORY DEFAULT.
EXIT
SAVE & EXIT – Exits the menu after saving the parameters.
EXIT – Exits the menu without saving the menu.