Eneo HDB-2080MIR - Manual (Page 19)

18
PIXEL DEFECT OFF
Detects and compensates the white pixels which becomes defective.
Once CALIBRATE is selected, the pixel calibration is initiated with lens closed
and can’t cancel.
THRESHOLD – Defines the level of detection and low value detects more
pixels. Be sure to set the value so that the pixels are uniformly blinking
over the entire screen. Too low value will get the bad results because
too many pixels are detected as the bad pixels and the maximum
number of pixels for compensation will be filled by the upper area.
EXECUTE☟- Long pressing will execute the pixel calibration for the
detected pixels. Menu will exit automatically after compensation.
TITLE SET -
Camera title(name) can be set and edited up to 15 alpha numeric and symbolic
characters from ASCII codes(ENGLISH only).
▲,▼,◀,▶ moves the cursor to choose a character and
● selects it.
The selected characters are added and displayed on the top left
Corner and the cursor moves right automatically for next input.
SP - Space is inserted when pressed ●.
BS – Cursor moves back when pressed ●.
CLR – Clears all the characters on input line when pressed ●.
POS – To be able to set the title position by ▲,▼,◀,▶ and ●.
DISPLAY -
Enables or disables to display the OSD.
ID – ON enables to display the camera ID defined by SYSTEM>COMM.
SETUP>CAM ID.
TITLE – ON enables to display the camera title(name) set by SPECIAL>
TITLE SET.
D-ZOOM RATIO – ON enables to display the zoom ratio on the bottom right
corner. DZx.x will display by multiplying the actual digital zoom ratio.
DEFOG OFF
AUTO – Enhance the foggy video automatically according to
status of scene
MANUAL – Sets to enhance the foggy video manually regardless of
status of scene
LEVEL – LOW, MID, HIGH
Video quality can be less in normal environments.
POINTING
ZOOM
OFF
ON enables to set off-centered location to be the center of zoom
H-POINTER, V-POINTER- Able to set the location of zoom center
D-Zoom is available DZ X1.0~ X8.0.
See ‘6.8.2 POINTING ZOOM’ for detail.