Eneo VMC-27LED - Manual (Page 29)

3. Connections
To make a normal connection to the monitor, bring a cord from a camera or other video source to one of the
BNC jacks or from a PC to the PC jack on the back of the monitor.
Either the left or right BNC jack can be used for input. The other jack may be optionally connected to another
user of the same signal.
Auto Termination The input circuit of the monitor normally terminates the incoming cable in 75 Ω, but these
BNCs jack are auto-terminating. When two cables are connected, the internal termination is switched out,
letting the final destination equipment provide the end termination.
This arrangement is also specially offered for the Y/C (S-Video) jacks.
* Supplied item
LED monitor
Power supply unit / Power cord
VGA cable
Operating instructions manual
9