Eneo VMC-27LED - Manual (Page 33)

● Advanced Menu
Advanced
Color Temp >
Alarm >
Energy Saving < OFF >
3D NR MID >
Anti Burn < OFF >
Recall >
Source
< CVBS1 >
Panel scale < Full >
• Color Temp is used to control color temperature. (User, Normal, Warm, Cool)
• Alarm is input for the alarm level (Max 5Vdc) of sensor or any alarm device.
• Energy Saving change the Display Backlight. (OFF, Medium, Maximum) (27” only)
When decreasing the backlight, the brightness of the black becomes darker without
any loss in video signal andthe power consumption is reduced.
• 3D NR reduce the noise in the picture due to poor reception or poor picture quality.
(Off/Low/Middle/High)
• Anti Burn: This is to prevent the pixel burn on LCD after the use of display for a long time.
You can turn it on in normal mode or under scan mode.
– ON in normal mode: 55minutes (normal screen) –> 5minutes (under scan screen) –>
55minutes (normal screen). Automatically being iterating.
– ON in under scan mode: 55minutes (under scan screen) –> 5minutes (normal screen) –>
55minutes (under scan screen). Automatically being iterating.
• Recall the monitor original factory setting.
• Source selects between the CVBS (Composite INPUT), S-Video (Super Video INPUT),
RGB (PC INPUT), DVR, DVI or HDMI to be displayed.
• Panel Scale
Change the scale. (4:3, Full)
Note: When viewing a fixed screen for an extended period of time, Residual image or blurriness may appear.
13