Endc, Evi is-is, Internal interface – H3C Technologies H3C S12500-X Series Switches User Manual

Page 10: Working mechanism, Neighbor discovery, Mac address learning

Advertising
background image

4

ENDC

An EVI neighbor discovery client works with an ENDS to learn neighbor information and triggers EVI link

setup between neighbors.

EVI IS-IS

EVI IS-IS establishes adjacencies and advertises MAC reachability information among edge devices at

different sites in an EVI network.
EVI IS-IS runs independently of the Layer 3 routing protocols on the transport network and sites.

DED

An inter-site DED is elected from between the edge devices on each EVI link to send CSNP packets for

LSDB synchronization.

Internal interface

Internal interfaces are site-facing Layer 2 interfaces that connect an edge device to switches or routers in

the site.

Working mechanism

An edge device uses the following process to set up an EVI network and forward traffic at Layer 2 to

remote sites:

1.

Runs ENDP to discover EVI neighbors and set up EVI links between neighbors.

2.

Runs EVI IS-IS to advertise MAC reachability information over EVI links in the EVI network.

3.

Forwards traffic based on MAC reachability information that has been received from other sites.

This section describes this process in detail.

Neighbor discovery

An EVI network runs ENDP to discover all its edge devices and establishes adjacencies among the edge

devices in the following process:

1.

ENDS is enabled on one edge device, and ENDC is enabled on all other edge devices.

2.

The ENDCs register their IP addresses and other data with the ENDS.

3.

The ENDS updates its ENDC database with received data and sends the updated database to
each ENDC.

4.

After receiving the register reply, the ENDCs establish an EVI link with each other.

For high availability, you can configure up to two ENDSs for an EVI network.

MAC address learning

MAC reachability information on an EVI edge device comes from the following sources:

MAC entries configured or learned in the data plane—The edge devices use the typical
source-MAC-based learning mechanism to learn unicast MAC addresses in their local sites (called

"local MAC addresses").

MAC entries learned through EVI IS-IS—After completing neighbor discovery, the edge devices run
EVI IS-IS in the control plane to establish adjacencies and advertise MAC reachability information

that has been learned or configured in the data plane to each other over EVI links.

Advertising
This manual is related to the following products: