H3C Technologies H3C S12500-X Series Switches - Manual (Page 17)

11
Step Command Remarks
3. Enable ENDS.
evi neighbor-discovery server
enable
By default, ENDS is disabled.
On an ENDS-enabled tunnel interface, you
can use the evi neighbor-discovery client
enable command to add one more ENDS,
and use the evi neighbor-discovery client
register-interval command to modify the
ENDC registration interval.
4. (Optional.) Enable
ENDP authentication.
evi neighbor-discovery
authentication { cipher | simple }
password
By default, ENDP authentication is
disabled.
Configuring the edge device as an ENDC on the EVI tunnel
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter EVI tunnel
interface view. interface tunnel number [ mode
evi ]
N/A
3. Configure the edge
device as the ENDC of
an ENDS.
evi neighbor-discovery client
enable server-ip
By default, ENDC is disabled.
If ENDS is enabled on the EVI tunnel
interface, you can use this command to
specify only one more ENDS.
If ENDS is disabled, you can repeat this
command to specify up to two ENDSs.
ENDS address is the tunnel source address
configured on an ENDS-enabled EVI tunnel
interface.
4. (Optional.) Enable
ENDP authentication.
evi neighbor-discovery
authentication { cipher | simple }
password
By default, ENDP authentication is
disabled.
All ENDSs and ENDCs in an EVI network
must use the same authentication key.
5. Configure the interval
at which the ENDC
updates its registration
with ENDSs.
evi neighbor-discovery client
register-interval time-value By default, an ENDC update its registration
with an ENDS every 15 seconds.
Enabling EVI on transport-facing physical interfaces
Enable EVI on all physical interfaces that provide transport network access for EVI tunnels. To avoid
forwarding failure, do not enable the spanning tree feature on these interfaces.
To enable EVI on an interface:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter Layer 2 or Layer 3
Ethernet interface view. interface interface-type
interface-number
N/A