H3C Technologies H3C SR8800 - Manual (Page 49)

40
Configuration procedure
1. Configure the protection mode:
# Create Layer 3 RPR logical interface RPR 1 on Station A, and configure the protection mode as
wrapping on the interface.
<StationA> system-view
[StationA] interface rpr 1
[StationA-RPR1] rpr protect-mode wrap
The configuration steps on Station B through Station E are similar to those on Station A and not
shown.
2. Configure static ringlet selection:
# On Layer 3 RPR logical interface RPR 1 of Station A, configure transmitting frames destined for
Station B through Ringlet 1.
[StationA-RPR1] rpr static-rs 000f-e257-0002 ringlet1
[StationA-RPR1] quit
3. Verify the configuration:
# Display ring topology information on Station A.
[StationA] display rpr topology ring
Ring-level topology information on interface: RPR1
Stations on ringlet0: 4
Stations on ringlet1: 4
Total stations on ring: 5
Jumbo preference: regular
Ring topology type: closed ring
# Display the static ring selection table information on Station A.
[StationA] display rpr rs-table static
Static ringlet selection table on interface: RPR1
MAC-Address Ringlet-ID Status
-----------------------------------
000f-e257-0002 Ringlet1 Valid
--- Total entrie(s): 1 ---
# Display the information about the overall ring selection table on Station A.
[StationA] display rpr rs-table overall
Overall ringlet selection table on interface: RPR1
MAC-Address Ringlet-ID TTL Type IP-Address Station-Name
--------------------------------------------------------------------------
000f-e257-0002 Ringlet1 4 static 0.0.0.0
000f-e257-0003 Ringlet0 2 dynamic 0.0.0.0
000f-e257-0004 Ringlet1 2 dynamic 0.0.0.0
000f-e257-0005 Ringlet1 1 dynamic 0.0.0.0
--- Total entrie(s): 4 ---