H3C Technologies H3C SR8800 User Manual

Page 96

Advertising
background image

87

<RouterB> system-view

[RouterB] ipv6

[RouterB] interface GigabitEthernet 4/1/1

[RouterB-GigabitEthernet4/1/1] ipv6 address fe80::2 link-local

[RouterB-GigabitEthernet4/1/1] ipv6 address 1::2 64

# Create a VRRP group 1 and set its virtual IPv6 addresses to FE80::10 and 1::10.

[RouterB-GigabitEthernet4/1/1] vrrp ipv6 vrid 1 virtual-ip fe80::10 link-local

[RouterB-GigabitEthernet4/1/1] vrrp ipv6 vrid 1 virtual-ip 1::10

# Set the authentication mode of VRRP group 1 as simple and authentication key as hello.

[RouterB-GigabitEthernet4/1/1] vrrp ipv6 vrid 1 authentication-mode simple hello

# Set the interval between sending VRRP advertisements to 500 centiseconds.

[RouterB-GigabitEthernet4/1/2] vrrp ipv6 vrid 1 timer advertise 500

# Configure Router B to work in preemptive mode, so that Router B can become the master after the

priority of Router A decreases to a value lower than 100. Configure the preemption delay as five
seconds to avoid frequent status switchover.

[RouterB-GigabitEthernet4/1/1] vrrp ipv6 vrid 1 preempt-mode timer delay 5

# Enable Router B to send RA messages, so that Host A can learn the default gateway address.

[RouterB-GigabitEthernet4/1/1] undo ipv6 nd ra halt

3.

Verify the configuration:
After the configuration, Host B can be pinged successfully on Host A. To verify your configuration,
use the display vrrp ipv6 verbose command.
# Display the detailed information of VRRP group 1 on Router A.

[RouterA-GigabitEthernet4/1/1] display vrrp ipv6 verbose

IPv6 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

Total number of virtual routers : 1

Interface GigabitEthernet4/1/1

VRID : 1 Adver Timer : 500

Admin Status : Up State : Master

Config Pri : 110 Running Pri : 110

Preempt Mode : Yes Delay Time : 5

Auth Type : Simple Key : hello

Virtual IP : FE80::10

1::10

Virtual MAC : 0000-5e00-0201

Master IP : FE80::1

VRRP Track Information:

Track Interface: GE4/1/2 State : Up Pri Reduced : 30

# Display the detailed information of VRRP group 1 on Router B.

[RouterB-GigabitEthernet4/1/1] display vrrp ipv6 verbose

IPv6 Standby Information:

Run Mode : Standard

Run Method : Virtual MAC

Total number of virtual routers : 1

Interface GigabitEthernet4/1/1

VRID : 1 Adver Timer : 500

Advertising
This manual is related to the following products: