H3C Technologies H3C LSWM1WCM10 Access Controller Module User Manual

Page 11

Advertising
background image

4

Configuration on an S5800 switch with access controller module LSWM1WCM20

# Create Layer 2 aggregate interface Bridge-Aggregation 1.

<S5800>system-view

[S5800]interface Bridge-Aggregation 1

[S5800-Bridge-Aggregation1]quit

# Add interfaces GigabitEthernet 1/1/1 and GigabitEthernet 1/1/2 that connect the switch and
LSWM1WCM20 to Bridge-Aggregation 1.

[S5800]interface GigabitEthernet 1/1/1

[S5800-GigabitEthernet1/1/1]port link-aggregation group 1

[S5800-GigabitEthernet1/1/1]quit

[S5800]interface GigabitEthernet 1/1/2

[S5800-GigabitEthernet1/1/2]port link-aggregation group 1

[S5800-GigabitEthernet1/1/2]quit

# Configure aggregate interface Bridge-Aggregation 1 as a trunk port and to permit all VLANs.

[S5800]interface Bridge-Aggregation 1

[S5800-Bridge-Aggregation1]port link-type trunk

[S5800-Bridge-Aggregation1]port trunk permit vlan all

[S5800]quit

3.

Configure the access control module

CAUTION:

Before you redirect to an access controller module from the switch, make sure the AUX port on the access
controller module is in none authentication mode, which is the factory defaults. For how to configure an

AUX port in none authentication mode, see

Table 3

.

Configuration for the access controller module LSQM1WCMB0 on an S7500E switch

# Redirect to LSQM1WCMB0 from the switch. In this example, LSQM1WCMB0 is inserted in slot 2.

<S7500>oap connect slot 2

Press CTRL+K to quit.

Connected to OAP!

<H3C>

# Configure interface Ten-GigabitEthernet 1/0/1 that connects LSQM1WCMB0 and the switch as a
trunk port and to permit all VLANs.

<H3C>system-view

[H3C]interface ten-gigabitEthernet 1/0/1

[H3C-Ten-GigabitEthernet1/0/1]port link-type trunk

[H3C-Ten-GigabitEthernet1/0/1]port trunk permit vlan all

[H3C]quit

Configuration for the access controller module LSWM1WCM20 on an S5800 switch

# Redirect to LSWM1WCM20 from the switch.

<S5800>oap connect slot 1 system SubSlot1

Press CTRL+K to quit.

Connected to SubSlot1!

<H3C>

# Create Layer 2 aggregate interface Bridge-Aggregation 1.

<H3C>system-view

Advertising