H3C Technologies H3C LSWM1WCM10 Access Controller Module - Manual (Page 31)

24
CPU Type : BCM1125H
CPU L1 Cache : 32KB
CPU Clock Speed : 600MHz
Memory Type : DDR2 SDRAM
Memory Size : 1024MB
Memory Speed : 166MHz
BootWare Size : 512KB
cfa0 Size : 259MB
CPLD Version : 010
PCB Version : Ver.C
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
At the prompt above, press Ctrl+B. The system prompts you for the password:
Please input BootWare password:
You have three chances to enter the BootWare password (the initial password is null). If you fail to enter
the correct password three times in a row, the system will be halted. You can only power off and power
on to restart the system. After you provide the correct password, the system enters the BootWare main
menu:
Note: The current operating device is cfa0
Enter < Storage Device Operation > to select device.
=============================<EXTEND-BOOTWARE MENU>=======================
|<1> Boot System |
|<2> Enter Serial SubMenu |
|<3> Enter Ethernet SubMenu |
|<4> File Control |
|<5> Modify BootWare Password |
|<6> Skip Current System Configuration |
|<7> BootWare Operation Menu |
|<8> Clear Super Password |
|<9> Storage Device Operation |
|<0> Reboot |
==========================================================================
Enter your choice(0-9):
Serial submenu
You can upgrade the application program, change the serial port baud rate and so on through this
submenu.
Select 2 in the BootWare main menu to enter the serial port submenu:
=============================<Enter Serial SubMenu>======================
|Note:the operating device is cfa0 |
|<1> Download Application Program To SDRAM And Run |
|<2> Update Main Application File |
|<3> Update Backup Application File |
|<4> Update Secure Application File |