H3C Technologies H3C SecPath F1000-E - Manual (Page 25)

9
To do... Use the command... Remarks
Create a Layer 2 aggregate
interface and enter the Layer 2
aggregate interface view
interface
bridge-aggregation
interface-number
Required
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
Exit to system view quit —
Enter Layer 2 Ethernet interface
view interface interface-type
interface-number
Assign the Ethernet interface to the
aggregation group port link-aggregation group
number
Required
Repeat these two steps to assign
more Layer 2 Ethernet interfaces to
the aggregation group.
Configuring a Layer 3 static aggregation group
Follow these steps to configure a Layer 3 static aggregation group:
To do... Use the command... Remarks
Enter system view system-view —
Create a Layer 3 aggregate
interface and enter the Layer 3
aggregate interface view
interface route-aggregation
interface-number
Required
When you create a Layer 3
aggregate interface, the system
automatically creates a Layer 3
static aggregation group
numbered the same.
Exit to system view quit —
Enter Layer 3 Ethernet interface
view interface interface-type
interface-number
Assign the Ethernet interface to the
aggregation group port link-aggregation group
number
Required
Repeat these two steps to assign
more Layer 3 Ethernet interfaces to
the aggregation group.
Configuring a Dynamic Aggregation Group
NOTE:
To guarantee a successful dynamic aggregation, ensure that the peer ports of the ports aggregated at one
end are also aggregated. The two ends can automatically negotiate the aggregation state of each member
port.
Configuring a Layer 2 dynamic aggregation group
Follow these steps to configure a Layer 2 dynamic aggregation group:
To do... Use the command... Remarks
Enter system view system-view —