H3C Technologies H3C SecPath F1000-E - Manual (Page 43)

27
RAGG2 S none 2 0 Shar
The output shows that link aggregation groups 1 and 2 are both load shared Layer 3 static aggregation
groups and each contains two Selected ports.
# Display all the group-specific load sharing criteria on Device A.
[DeviceA] display link-aggregation load-sharing mode interface
Route-Aggregation1 Load-Sharing Mode:
source-ip address
Route-Aggregation2 Load-Sharing Mode:
destination-ip address
The output shows that the load sharing criterion for link aggregation group 1 is the source IP address and
the load sharing criterion for link aggregation group 2 is the destination IP address.