H3C Technologies H3C SecPath F1000-E - Manual (Page 32)

16
To do... Use the command... Remarks
Display the global or
group-specific link-aggregation
load sharing criteria
display link-aggregation load-sharing
mode [ interface [ { bridge-aggregation |
route-aggregation } interface-number ] ]
Available in any view
Display detailed link aggregation
information for link aggregation
member ports
display link-aggregation member-port
[ interface-list ]
Available in any view
Display summary information
about all aggregation groups
display link-aggregation summary Available in any view
Display detailed information about
a specific or all aggregation
groups
display link-aggregation verbose
[ { bridge-aggregation |
route-aggregation } [ interface-number ] ]
Available in any view
Clear LACP statistics for a specific
or all link aggregation member
ports
reset lacp statistics [ interface
interface-list ] Available in user
view
Clear statistics for a specific or all
aggregate interfaces
reset counters interface
[ { bridge-aggregation |
route-aggregation } [ interface-number ] ]
Available in user
view
Ethernet Link Aggregation Configuration Examples
NOTE:
•
In an aggregation group, only ports that have the same port attributes and class-two configurations (see
the
Configuration classes section) as the reference port (see the Reference port section) can operate as
Selected ports. Therefore, you must ensure that all member ports have the same port attributes and
class-two configurations as the reference port. The other settings only need to be configured on the
aggregate interface, not on the member ports.
• Before configuring Layer 2 aggregation, configure the interfaces you want to add to the Layer 2
aggregation group as Layer 2 ports by using the port link-mode command.
Layer 2 Static Aggregation Configuration Example
Network requirements
As shown in Figure 4 :
• Device A and Device B are connected through their respective Layer 2 Ethernet interfaces
GigabitEthernet 0/1 through GigabitEthernet 0/3.
• Configure a Layer 2 static aggregation group on Device A and Device B respectively; enable VLAN
10 at one end of the aggregate link to communicate with VLAN 10 at the other end, and VLAN 20
at one end to communicate with VLAN 20 at the other end.