H3C Technologies H3C SecPath F1000-E - Manual (Page 48)

4
To do... Use the command... Remarks
Employ PAP
See “ Configuring PAP
authentication .”
Configure PPP
authentication mode
Employ CHAP
See “ Configuring CHAP
authentication .”
Optional
You can configure
several authentication
modes simultaneously. In
LCP negotiation, the
authenticator negotiates
with the authenticatee in
the sequence of
configured authentication
modes until the LCP
negotiation succeeds. If
the response packet from
the authenticatee carries
a recommended
authentication mode, the
authenticator directly
uses the authentication
mode if it finds the mode
configured.
PPP authentication is
disabled by default.
Configure PPP negotiation
See “ Configuring PPP
negotiation .”
Optional
Enable PPP traffic statistics collection
See “ Enabling PPP traffic
statistics collection .”
Optional
Configure a PPP user binding rule
See “ Enabling PPP user
binding .“
Optional
Configuring PAP authentication
Configuring the authenticator
Follow these steps to configure the authenticator:
To do… Use the command… Remarks
Enter system view system-view —
Create a VT interface and enter VT
interface view
interface virtual-template number —
Configure the local device to
authenticate the peer by using PAP
ppp authentication-mode pap
[ [ call-in ] domain isp-name ]
Required
By default, PPP authentication is
disabled.
Return to system view quit —
Create a local user account for the
authenticatee and enter local user
view
local-user username Required