Grass Valley 8964MON - Manual (Page 15)

8964MON Instruction Manual 15
Configuration
Local Onboard Module Configuration
The 8964MON module can be configured locally using the rotary and
paddle switches. Several LEDs interact with the switches to indicate status
of the configuration process.
Configuration Switches and Controls
Each of the four encoder channels is adjusted separately. Selection of each
channel is done with the paddle switch while in Channel Select Mode as
explained below. Refer to
Figure 5 on page 16 for the following descrip-
tions. Use the onboard configuration components as follows:
• SW1 Function (rotary) switch — This switch accesses a desired function
for configuration (see
Table 5 on page 17 ).
Note The Function switch should be kept in position 0 (parked) when not in use to
avoid any inadvertent change in configuration. Position 0 is inactive.
• SW3 (paddle) switch – actuates or selects the desired setting or channel
selection for the selected function when the switch is held momentarily
in either the up or down position. Switch between Parameter and
Channel Select Mode with pushbutton SW2.
• CSM (Channel Select Mode) yellow LED – when on, paddle switch is in
Channel Select Mode. Use the paddle switch to select channel 1, 2, 3, or
4. When off, paddle switch is in Parameter mode.
• CM1 and CM0 yellow LEDs – indicate what channel is active for adjust-
ment. Refer to
Table 4 on page 16 .
• SW2 (pushbutton) switch – press to toggle assignment of paddle switch
SW3 between Parameter mode (CSM LED off) and Channel Select
Mode (CSM LED on).
• CONF (configuring) yellow LED – when on, indicates the module is
programming hardware.