Grass Valley 8964MON - Manual (Page 28)

28 8964MON Instruction Manual
Configuration
Composite Out Web Page
Use the Composite Out web page ( Figure 15 on page 29 ) to make final
adjustments to the composite output video on each channel or all channels
together. Select the channel to be adjusted from the
Channel 1– 4 buttons.
Set the following adjustments for each channel with this web page:
• Enable a color bars test signal by selecting the Color Bars radio button.
• In 525 mode, the Setup section will appear with an Add checkbox enabled
by default. Uncheck the Add checkbox to remove setup from the output
video if desired.
• Adjust the percent of Output Video Gain on each channel relative to
100%.
Use the single or double arrow keys to change gain values then click on
the
Apply button to activate gain settings. You may also enter a value in
the field with a keyboard and select the Ente r key to activate the value.
Each of the four output channels can be adjusted separately or settings
can be applied to other or all channels. Use the
Apply Setting To ( Channel 1,
2, 3 or 4 as applicable) or All buttons to apply the same values to the
other channels selected or all channels.
To reset the current channel or all channels to factory defaults, select the
Reset defaults for
Current Channel or All Channels buttons.
Note VBI data is automatically blanked on all output channels.
Use
this
link