Grass Valley iControl Solo v.4.13 - Manual (Page 11)

Release Notes
iControl Solo version 4.13 is a minor release containing a few new features, enhancements,
and bug fixes. The Release Notes list new features, bug fixes, known issues and limitations,
and the cards and devices supported in this release.
New Features and Enhancements
New in Version 4.12
Densité Services
• [Ref. #32704] iControl Solo Version 4.12 now supports the Axino Multi-Program IP Transport
Stream Loudness Processor. The Axino probes and analyzes embedded audio signals within
a multi-channel signal and enables automatic loudness control.
New in Version 4.11
Densité Services
• [Ref. #32344] HDA-193N-D-3SRP-F: iControl Solo introduces the new REAR module
HDA-193N-D-3SRP-F in support of the HDA-1931 and HDA-1911 Densité cards.
• [Ref. #29942] HMP-1801: iControl Solo now allows you to select a serial protocol (either
Oxtel or VDCP) on the control panel of firmware version 5.1.0 or later of the HMP-1801
Densité card.
IMPORTANT: This feature in BETA mode in iControl Solo version 4.12
iControl Solo version 4.12 only supports the Axino Multi-Program
IP Transport Stream Loudness Processor in BETA mode.
See also
For more information, see the Axino Multi-Program IP Transport Stream Loudness
Processor Guide to Installation and Operation (M948-9900-100).
IMPORTANT: If your HMP-1801 card does not have firmware version 5.1.0 or later, the
Protocol tab will not be available.
See also
For more information, see the HMP-1801 High Definition Media Player Guide to
Installation and Operation (M864-9900-108).