Grass Valley iControl Solo v.4.13 - Manual (Page 18)

Release Notes
Cards and Devices Supported in this Release
14
• [Ref. #19004] When you open a service’s control panel by using the Show Info control panel
command (right-click a device in the Navigator view, and then click Show info control
panel on the shortcut menu) it sometimes happens that the Info tab does not receive the
focus.
Workaround: Once the control panel is open, click the Info tab.
• Some card services like the HCO-1821, the XVP-811 or the DAP-781 may take up to 60
seconds to initialize. In this case, the card may appear in the selected Navigator view but
the associated control panel will not show statuses and parameter values.
• Startup time may be affected by having multiple frames configured in the Densité
Manager, even if they are set to Standby.
• It can take up to two minutes to discover and initialize an Imaging frame.
• On rare occasions, the copy profile feature available with many of our Densité cards may
not successfully copy parameters to all cards.
Workaround: Reduce the number of cards to which parameters are copied.
• It could take up to one minute for iControl Navigator to know that services are no longer
available.
• The Miranda Imaging Quartet 1 and Solo frame are not supported.
• Thumbnail, ALM and CC streaming on Miranda Densité series probes is not supported.
• The Reference Config feature (Config Status in Navigator) is not supported.
Cards and Devices Supported in this Release
Densité Cards
iControl Solo version 4.13 is compatible with both Densité Ethernet Controller (CPU-ETH and
CPU-ETH2). In the case of CPU-ETH, it is strongly recommended to upgrade to the latest Densité
Ethernet Controller version (3.00 or later). Any CPU-ETH2 version can be used but it is
recommended to use version 2.0.4 or later.
For each Densité Series card supported in this release, the following table provides the card
model, the currently supported firmware version of the card, and the iControl Solo version
number that first supported this model.
The star (

) symbol indicates a new card, or new version of a card, that is supported in this
release.
Latest Densité card firmware versions supported by iControl Solo
Card Model Firmware Version Introduced in iControl
3DX-3901 1.2.0 3.70
AAP-1741 1.0.1 3.20 or earlier
ACP-1721 3.2.1 3.20 or earlier
ADA-1001 3.20 or earlier