Grass Valley iControl Solo v.4.13 - Manual (Page 14)

Release Notes
Densité Services
10
New in Version 3.70
Densité Services
• [Ref. #27941] 3DX-3901: Support for the new 3DX-3901 card (firmware version 1.1.0) . The
3DX-3901 is a new Densité card which provides all essential stereoscopic signal processing
functions on a single card.
• [Ref. #27128] HMP-1801: Support for firmware version 5.0.0 of the HMP-1801 Densité card.
This version introduces a new 3D option.
• [Ref. #27027] WDA-1001: Support for the new WDA-1001 card (firmware version 1.0.0). The
WDA-1001 is a World Clock Distribution Amplifier which provides 8 outputs and support
for a wide range of clock frequencies and amplitudes.
• [Ref. #27026] DDA-1113/DDA-1133: Support for the new DDA-1113/1133 cards, digital
audio (DA) cards that support AES3 digital audio standards (75 and 110 ohm) and provide
9 outputs.
• [Ref. #27024] FIO-1901: Support for the new FIO-1901 series of cards, which provides serial
digital video to/from fiber optic cable for the Densité frames. The series supports SD, HD,
3Gbps and DVB-ASI signals using SFP modules in many different configurations.
• [Ref. #27006] IRD-3811: New iControl Solo alarms to log BER, CNR and signal-strength
problems that may be encountered with the DVB-S2 and VQ modules.
• [Ref. #26534] AMX-3981, ADX-3981: Support for firmware version 2.0.0. This version adds
various hardware options, such as Automatic Loudness Control from Linear Acoustic and
Junger Audio, Dolby Digital (AC-3) encoder, Dolby E & Digital (AC-3) decoder, etc.
• [Ref. #26534] EAP-3901: Support for the new EAP-3901 and EAP-3101 cards (firmware
version 2.0.0). The EAP-3901 is an advanced embedded audio processor supporting
3Gbps/HD/SD input. The EAP-3101 is limited to SD-In. Both cards provide down-mixing,
Proc Amp, channel shuffling and mixing, and options for Automatic Loudness Control
(ALC), Dolby encoding and decoding.
• [Ref. #26534] EAP-3101: Support for the new EAP-3101 card (firmware version 2.0.0), which
is an audio processor card similar to the EAP-3901 but supporting an SD input only.
• [Ref. #26533] SCO-1421: Support for the new SCO-1421 card (firmware versions 101
and 200). The SCO-1421 is a 2 × 1 intelligent ASI changeover switch with built-in MPEG-TS
probing.
• [Ref. #25724] FXE-1501: Support for the FXE-1501 card. This card is an Ethernet-to-Fiber
transceiver that converts 10/100/1000BASE-T Ethernet over unshielded twisted pair (UTP)
to 1000BASE-SX/LX Gigabit Ethernet-over-fiber, using an SFP module.
Note: The FIO-1901 Densité cards in iControl Solo 3.70 are in Beta stage.